Working width, track width, chassis width and overall machine width answer different questions. A buyer can select the correct cutting width and still receive a machine that cannot clear a gate, turn at the row end or load onto the intended trailer. Access must be measured against the complete ordered configuration.
Direct recommendation
Measure the narrowest gate, row and transport point at the height where the machine and attachment pass. Request final overall length, width and height, not only cutting width. Draw the approach and turn, then add clearance for crop growth, uneven ground, steering correction and safe separation.
Decision framework
| Decision | Verified planning rule |
|---|---|
| Cutting width | The nominal vegetation-processing swath |
| Chassis or track width | Undercarriage reference; not always overall width |
| Overall width | Widest point of the final configured machine |
| Attachment envelope | Space swept by cutter, blade or other equipment |
| Turning area | Usable geometry including approach, obstacles and surface |
Create an access inventory
List the loading point, trailer, ramps, storage door, farm gate, bridges, paths, crop rows and headlands. For each point record usable width, height, length, slope, surface and fixed obstacles. The smallest number is not automatically the only constraint because approach angle can control the route.
Measure where the widest component passes
A low wall may constrain the tracks while foliage or a post constrains the upper body. Use a vertical sketch with measurements at relevant heights. Include guards, controls, exhaust, fan, boom, snow blade and other ordered equipment.
Draw the turning movement
Skid steering can rotate within a compact footprint, but the corners and attachment still sweep an area. Stationary turns can disturb soft turf. Mark a practical moving turn and verify that the complete machine stays clear of crops, drop-offs and people.
Check loading as a separate route
Compare machine mass and dimensions with trailer rating, deck, ramps, tie-down points and local transport requirements. Confirm approach and breakover clearances. A machine that fits the work row can still be incompatible with the buyer’s transport system.
Send evidence with units
Photograph a ruler or tape at the narrowest locations and label every measurement in millimetres or another explicit unit. State whether the number is clear opening or centre-to-centre spacing. This prevents conversion and interpretation errors.
Freeze the final envelope in the quotation
When engine, deck, actuator or attachment changes, recheck the dimension drawing. Record the approved configuration and overall dimensions beside the model so later option changes cannot silently invalidate the access review.
Evidence to send before ordering
- Exact model shortlist and required option or attachment.
- Representative site photos, measurements, route, task and finish.
- Daily workload, maintenance capability and destination.
- Questions that must be answered in the final quotation and TDS.
Related MERI resources
Buyer FAQ
Does an option-library image prove compatibility?
No. MERI must confirm the option for the exact model and ordered configuration.
Can a site video replace the product documentation?
No. It records one configuration and set of conditions; use the current TDS and quotation for the order.
Should final dimensions and weight be requested again after options change?
Yes. Recheck access, transport and operating plans against the final configuration.
Confirm the exact model and option
Send the site, task and preferred configuration for a compatibility review.
Need a mower recommendation for your terrain or project?
Get a Quote