Tracked MERI machines lined up on the workshop floor
Compare machines by the work they need to do on your site.

Remote Mower Selector

Filter 22 MERI models by job, slope, work width, power and the area you need to cover.

  • ISO 9001
  • Exported to 100+ countries
  • Reply within 24 hours

Filter models by your job and site

Enter the steepest section you plan to cut and the working width you can use. If you know the area and time available, the tool will also check the required hourly output against the technical sheets.






Leave measurements blank to skip those filters. Fill in both area and hours to filter by hourly output.

JavaScript is required for these filters. Browse the product range to compare the individual technical sheets.



How to choose a remote mower

  1. Measure the steepest part of the working area and the narrowest point on the access route.
  2. Choose a tool for the vegetation and set the cutting width you need. Check overall machine width separately.
  3. Enter your area and working time, then compare the shortlisted technical sheets. Ask MERI about any missing figures.

Starting points for common jobs

JobStarting point
Steep slopesTry 30° as an example, then enter your measured working slope.
Orchards and vineyardsStart with a 1,000 mm cutting width, then check the clear space between rows.
Large sitesStart with 2 hectares in 4 hours and adjust to your own schedule.

Measure the work area and the access route

Tracked MERI mower on a grass bank
Check the steepest section of the work area as well as the route into it.

Start with the machine’s job. A cutting width for a grass mower, a rotary-tiller width and a snow-clearing width describe different work. The tool keeps them separate so you can compare like for like.

Measure the steepest part that needs work, then note the narrowest gate and where the machine will turn. Allow time for turns, obstacles and travel when you set an hourly target.

Compare the 800 mm ME800-48 and the 1000 mm ME1000-48, or read the slope mower guide for site measurements.

Frequently asked questions

Can I use maximum grade as a mowing limit?

Use the working slope field when selecting a mower for a slope. Maximum grade describes climbing capability. If a technical sheet only lists a climbing figure, ask for the operating limit before you shortlist the machine.

Why do some models need more information?

A model needs more information when its sheet does not give a value for one of your filters. It stays visible in a separate list so you can ask for the missing specification.

How does the area filter work?

Enter area in hectares and the time available in hours. The selector divides the area in square metres by the hours and compares that target with the published maximum hourly output, where available.

Is working width the same as the width of the machine?

Working width describes the cutting or working span. Use overall machine width for gates, trailers and narrow paths. Check turning room and the clearance around obstacles as well.

What should I send for a model recommendation?

Send the task, the steepest work area, gate width, the vegetation or ground condition, and a photo of the narrowest access. Include the area and available hours if you have a work target.

Get a shortlist for your site

Send us the slope, access dimensions and a photo of the work area. We reply within 24 hours.

Ask for a model recommendation