Boom Sprayer Nozzle Spacing and Height: Check the Whole Pattern — remote control agricultural sprayer article

Visible banding points to uneven coverage across the swath. Start by recording the exact nozzle tip code, center-to-center spacing and tip-to-target height. Pressure changes droplet size and flow within the tip's operating range. It cannot correct a twisted nozzle body, an uneven boom or the wrong spacing for the fitted tip.

Sprayer nozzle assembly on MERI equipment
Sprayer nozzle assembly on MERI equipment.

Start with the hardware you actually have

Record the exact nozzle code and measure the distance between neighboring outlets from center to center. Confirm whether the nozzles are identical across the section you are checking. Use the tip manufacturer's chart for the recommended spacing and height. Measure height from the tip to the target surface specified for the application. When treating a crop canopy, a measurement from the boom to bare soil can give you the wrong reference.

Field checklist

CheckWhat to record
Repeated light bandsCheck overlap, tip spacing and tip-to-target height.
One abnormal fanCheck the affected tip, filter and nozzle orientation.
One side differsCheck level and height across the boom.

Read the pattern across the boom

With clean water and a test area suitable for the machine, run the sprayer using the approved calibration procedure. Compare spray patterns under neighboring tips and in the areas between them. A recurring light band between tips points toward a possible overlap or setup issue. One visibly abnormal fan calls for a closer look at its tip, filter, orientation and outlet. A pattern that changes from one end of the boom to the other calls for a level and height check across the full span. Keep people clear of the boom and depressurize before servicing a tip or filter.

Keep two checks separate

Pattern checks show where spray lands. Output calibration checks how much liquid is delivered. A visually even pattern alone does not establish application rate. Record the nozzle code, spacing, target height and test results so the same setup can be checked again after a tip change or boom repair. Follow the pesticide label and equipment instructions for any product application.

Request a boom configuration

Send MERI your target crop, row layout, nozzle code and planned boom arrangement. The RCS range includes boom and airblast configurations. Confirm the supplied equipment and nozzle chart for the specific order.

Frequently asked questions

Does an even pattern establish application rate?

Use a separate output calibration to establish application rate. The pattern test shows where the spray lands.

Which boom height should I use?

Use the chart for the fitted tip and the target reference specified for the application.

Talk to MERI about your setup

Need a agricultural sprayer recommendation for your terrain or project?

Get a Quote
Get a Quote