
Short answer: Many tracked remote machines use hydraulic motors to drive the tracks. MERI machines drive the tracks with electric motors, powered by a battery charged by the engine generator. That means no hydraulic hoses in the drive, simple speed control from the remote, and fewer fluids to service.

Two ways to drive the tracks
| Point | Hydraulic drive | Electric drive |
|---|---|---|
| Power path | Engine, pump, hoses, motors | Engine, generator, battery, motors |
| Service | Oil, filters, hoses | Connectors, battery |
| Leaks | Possible at hoses | No hydraulic fluid in the drive |
| Control | Valves | Electronic speed control |
What MERI machines use
| Machine | Travel drive (TDS) |
|---|---|
| 48 V flail mowers | 2 × 1,000 W motors, 48 V |
| 24 V flail mowers | 1,800 W, 24 V |
| T-Series | 24 V, 1,100 W (ME550-T/650-T) or 1,300 W (ME900-T) |
| ME-RFM1000-D | Dual motors, 1,500 W |
| ME-RT Series | 2 × 800 W, 24 V |
| ME-RS600 | 2 × 300 W, 24 V |
From MERI TDS.
Why it matters to an owner
With no hydraulic hoses in the travel drive, there is no hydraulic oil to change for the tracks and no hose to burst on a slope. The engine keeps the battery charged while it runs, so working time depends on fuel rather than a fixed battery charge. Keep connectors clean and dry and the battery charged during storage.
Where hydraulics still appear
Some MERI machines use hydraulics for lifting: Pro mowers have remote hydraulic lift, and the ME-RFM1000-D lifts its head hydraulically. Check those hoses for wear and leaks as part of routine service.
Maintenance
| Drive | Typical checks |
|---|---|
| Electric travel motors | Battery, connectors, controller, motor temperature |
| Hydraulic drive | Oil level and grade, filters, hoses, cooler |
Choosing
Ask for the drive type of each model and match it to your duty, climate and service skills. MERI 48 V models use two 1,000 W travel motors (2 × 1,000 W).
Worked example: daily checks on an electric drive
- Look at the main connectors and the controller for dirt, water and loose plugs.
- Check the battery terminals are clean and tight.
- Drive a short straight line on flat ground and check the machine tracks straight.
- After work, feel the motor housings. One much hotter than the other can point to a drag on that side.
- Clean the undercarriage so mud and grass do not load the motors.
These checks take a few minutes and need no fluids or filters for the travel drive.

Slopes and stopping
On a slope, the drive has to hold the machine as well as move it. Electric travel motors are controlled electronically from the remote, so speed changes are smooth and the machine stops when the operator stops it. If the remote signal is lost, MERI machines stop. Work slopes within the rating, 45° for MERI tracked mowers, and less on wet grass or loose soil.
Common questions from buyers
| Question | Short answer |
|---|---|
| Does the battery run the whole job? | The engine charges it through a generator while it runs |
| Is there hydraulic oil in the track drive? | No, the travel drive is electric |
| Are there any hydraulics at all? | Some models use hydraulic lift, such as Pro mowers and the ME-RFM1000-D head |
| What wears out? | Tracks, idlers and rollers, like any tracked machine |
See the drive motors and batteries guide for figures by model.
Seasonal care for the electric drive
- Before the season: charge the battery fully, check terminals and test drive on flat ground.
- During wet months: keep connectors dry and avoid pressure washing near the controller.
- In hot weather: clean the machine so dirt does not trap heat around motors and electrics.
- Before storage: clean, dry, charge the battery and store the machine under cover.
A hydraulic drive needs the same cleaning plus oil, filter and hose checks. That is the main service difference an owner will notice.
What to ask your dealer
- Which parts of this model are electric and which are hydraulic?
- Which travel drive spares does the dealer keep in stock, such as the drive motor assembly and controller?
- What does the operator manual say about washing near the electrics?
- Who can test the battery and charging system if the machine starts slowly?
Clear answers to these questions tell you how the machine will be supported in your area.
Related MERI pages
Frequently asked questions
Do MERI mowers use hydraulic track drive?
No. The tracks are driven by electric motors.
What powers the electric motors?
A battery charged by the engine generator while it runs.
Are there any hydraulics on MERI machines?
Yes, for lifting on Pro mowers and the ME-RFM1000-D head.
What travel motors do 48 V mowers use?
Two 1,000 W motors at 48 V.
Send us your site details
Tell us the job, area, slope and country. MERI replies within 24 hours.
Need a mower recommendation for your terrain or project?
Get a Quote