
Short answer: A flat transmitter stops a remote mower as surely as an empty fuel tank. Check the remote battery before each shift, carry a charged spare or spare cells, charge in the van between sites, protect batteries from cold and wet, and keep a spare remote for fleets that cannot afford downtime.
Two batteries, two jobs
A remote mower has two separate power sources to think about. The machine has its own battery system for starting and electric drive. The hand-held transmitter has a small battery of its own. This article is about the transmitter. If it goes flat in the middle of a bank, the machine stops, and the crew loses time walking back to the van.
Know your remote
MERI mowers ship with the C7 remote as standard: 2.4 GHz radio, up to 800 m range. The optional R1 industrial remote reaches up to 1,000 m, and KBR industrial remotes are available by configuration. Battery type and charging method depend on the remote model. Read the remote manual, or ask MERI for the battery details of the remote fitted to your machine.
Daily routine
| When | Check |
|---|---|
| Start of shift | Battery level on the remote; spare charged |
| Before each site | Battery level; emergency stop works |
| Breaks | Top up charge if the remote allows it |
| End of shift | Charge remote and spare; clean and dry the case |
| Weekly | Battery contacts, case seals, strap and antenna |
Adjust to the battery type and the manual for your remote.
Spares worth carrying
- A charged spare battery or a set of fresh cells, as your remote uses.
- A vehicle charger or power bank that suits the remote, if it is rechargeable.
- A spare remote paired to the machine, for fleets with tight schedules.
- A weatherproof pouch or case.
- A copy of the pairing procedure, so a spare can be used on site.
Charging on the road
Crews moving between sites can charge in the vehicle. Use a charger rated for the battery and do not leave batteries charging unattended in a hot cab. Label batteries and rotate them, so one is not always flat and one always full. Write the charge routine into the crew checklist so it does not depend on memory.

Cold, heat and wet
Batteries lose capacity in the cold. In winter, keep the remote and spare in an inside pocket or the cab until you start. In hot weather, keep them out of direct sun on the dashboard. Rain and washing water are the other enemy: keep the remote dry, and never wash it with a jet.
If the remote fails on site
If the transmitter loses power or the radio link drops, a MERI machine stops. Walk to a safe position, check the battery and the emergency stop, and restart according to the manual. If the fault returns with a good battery, write down what happened, the date and the machine hours, take a photo of any warning, and contact support with those details.
Storage between seasons
Before the off-season, charge or remove batteries as the manual advises. Store the remote somewhere dry and cool, not in an unheated shed through winter. Check and charge again before the first job of the next season.
Fleets with several machines
With several machines, remotes get mixed up. Mark each remote and its machine with the same number, and keep spare batteries in a labelled box per crew. Record in the daily log which remote went out with which machine. If a remote is dropped or gets wet, take it out of use until it has been checked, rather than finding out on a steep bank that the emergency stop does not respond.
Testing the remote before each job
- Check the battery level on the remote and the machine before leaving the vehicle.
- Start the machine and test the stop button before any cutting.
- Test each drive and cutting control at low speed on flat ground.
- Check the signal-loss stop as the manual describes; MERI machines stop if the signal is lost.
- Record any fault and do not work on slopes until it is fixed.
Related MERI pages
- Remote controller options
- Remote control radio and range
- Battery drains overnight
- Starter battery voltage drop
- What to record for support
Frequently asked questions
What happens if the remote battery goes flat?
The radio link is lost and a MERI machine stops. Change or charge the battery and restart according to the manual.
Which remote comes with MERI mowers?
The C7 remote, 2.4 GHz, up to 800 m. The R1 industrial remote, up to 1,000 m, is optional.
Should I carry a spare remote?
Fleets with tight schedules should carry a spare paired to the machine.
How do I protect remote batteries in winter?
Keep the remote and spare warm in a pocket or the cab until you start work.
Send us your site details
Tell us the job, area, slope and country. MERI replies within 24 hours.
Need a mower recommendation for your terrain or project?
Get a Quote