
Short answer: Use a sweeper brush for light, fresh snow on paths and paved areas where you want a clean surface. Use a blower when snow is deeper or there is nowhere to pile it. Use a plow on open yards with room at the edges. The MERI ME-RS600 takes both a 600 mm blower head (standard) and an 800 mm brush (optional) on the same tracked platform.
Dealers and site managers often ask which head to put on a remote snow machine. The honest answer depends on three things: how much snow usually falls, where it can go, and what surface you are clearing. This guide walks through each head and how to choose.
How each head moves snow
A sweeper brush spins a cylinder of bristles. It flicks snow forward and to the side. It works close to the surface, so it leaves paving cleaner than a blade. It is best on thin layers that have not packed down.
A blower uses an auger to gather snow and push it into a chute. The chute throws snow clear of the route. It handles deeper snow and keeps the cleared path free of side piles.
A plow pushes snow ahead and to one side. It is simple and fast on open ground. But it needs space at the edges to build piles, and piles grow through the winter.
Sweeper, blower or plow: side-by-side
| Question | Sweeper brush | Blower | Plow |
|---|---|---|---|
| Typical snow | Light, fresh layers | Moderate to deep snow | Light to moderate snow |
| Where snow goes | Short throw to the side | Thrown clear through the chute | Pushed into piles at the edges |
| Finish on paving | Cleanest | Good, thin layer may remain | Depends on blade edge |
| Best fit | Walkways, platforms, entrances | Narrow routes with no pile space | Open yards and car parks |
Source for MERI options: the MERI snow removal equipment overview and the ME-RS600 product page.
What MERI offers for each head
The ME-RS600 compact snow blower is the machine to look at if you want both a brush and a blower. Its product page lists:
- 600 mm snow blower head as standard, with a chute that rotates up to 180°
- 800 mm sweeping brush as an option, fitted to the same tracked platform
- Loncin 196 low-temperature gasoline engine, 8 hp
- Two 24 V, 300 W electric travel motors and 120 mm tracks
- 500 m remote control range and 192 kg operating weight
- 4–6 km/h travel speed and 35° maximum climbing angle

For larger sites, the ME-RS snow blower is a separate, bigger machine. It offers 600, 800 or 1000 mm clearing widths, a 16 hp Loncin engine, a 3–5 m throw and an 800 m remote range. Its page does not list a brush. If you need a blower and a plow on one site, see the ME-RS dual-end machine.
Choose by snow, space and surface
- Check your usual snowfall. If most events leave a thin layer, a brush covers most of the season. If you often get deeper falls, start with a blower.
- Check where snow can go. No room to pile snow beside the path? Use a blower. Wide edges? A plow or brush can work.
- Check the surface. Brushes suit paving, decks and platforms where a clean finish matters.
- Check timing. A brush works best on fresh snow. Once traffic packs it down, it is much harder to sweep.
- Measure the narrowest point. The ME-RS600 lists 600 mm overall width with the blower head. The brush sweeps 800 mm, so the machine is wider with it fitted. Measure gates and rail gaps first.
When one head is not enough
Many sites get both light and heavy snow in one winter. On the ME-RS600, you can keep the blower for deep falls and fit the brush for light days and finishing. Plan for the time it takes your crew to swap heads, and store the spare head where it stays dry.
On open yards, a plow on a tracked machine is often the simplest tool. The remote snow plow buying guide covers plow sizing and pile space. For ramps and crossings, read our notes on clearing accessible curb ramps.

What to send MERI
- Site type and a few photos of the paths, ramps or platforms
- Typical snow depth and how often it snows
- Narrowest gate or gap, and the steepest ramp
- Surface type: asphalt, paving, decking or other
- Whether you want a brush, a blower, or both
- Destination country and quantity
Frequently asked questions
When is a sweeper brush better than a snow blower?
A brush suits light, fresh snow on paths, platforms and paving where you want a clean surface. For deeper snow, or where there is no room to pile it, a blower is the better choice.
Can one MERI machine use both a brush and a blower?
Yes. The ME-RS600 product page lists a standard 600 mm blower head and an optional 800 mm sweeping brush. Both fit the same tracked platform.
Does the larger ME-RS take a sweeping brush?
The ME-RS product page lists 600, 800 or 1000 mm blower widths and does not list a brush. Ask MERI if you need sweeping on that machine.
Will a brush clear packed snow?
A brush works best before snow is packed by traffic. Plan to sweep early, or use a blower or plow for packed and deeper snow.
Choose the right snow head for your sites
Send your site photos, usual snow depth and narrowest gate. MERI will recommend a head setup for dealer or fleet orders.
Need a mower recommendation for your terrain or project?
Get a Quote