Mower Pulls to One Side on Slopes: Track Tension and Settings — remote control lawn mower article

Short answer: Some downhill drift on a side slope is normal: gravity pulls the machine down. Reduce it by working up and down where the manual allows, slowing down, keeping track tension even and avoiding wet grass. If it pulls on flat ground too, check the tracks and drive as for a slow track.

Normal drift or a fault?

Drive straight on flat ground. If the machine holds its line there but drifts on a bank, that is mostly gravity and grip. If it pulls on flat ground too, look for a mechanical or electrical cause.

Working a bank

  • Follow the travel direction in the manual for your model.
  • Slow down on the steepest part.
  • Avoid wet grass and loose soil; grip drops well below the rating.
  • Make turns on flatter ground at the top or bottom.
  • Keep the operator up-slope or to the side, never below.

MERI mowers are rated to 45° in suitable conditions. That is a limit, not a target.

Checks on the machine

Do all checks with the engine off, the remote switched off and the machine secured, as the operator manual says.

  • Track tension equal on both sides.
  • Tracks not worn smooth; check the tread.
  • No mud packed on one side.
  • Cutting height set evenly.

When the cutting head is the cause

A heavy cut on the downhill side can drag the machine. Raise the cutting height a little on steep banks or cut in two passes.

A simple test run

Mark a straight 20 m line on flat ground and drive along it at working speed with the cutter off, then with the cutter on. Repeat on the bank. If the machine only drifts with the cutter running, the cutting load is the cause; if it drifts on the flat with the cutter off, look at the tracks and drive. Note the result before calling your dealer.

Operator technique

Some pull on slopes is normal as weight shifts downhill. Steer slightly uphill to hold a line, slow down and avoid long cross-slope runs on wet grass.

Worked example: a 35° roadside bank

An operator cuts a 35° bank on a dry morning and the machine holds its line well. After a shower, on the same bank, it drifts downhill on every pass. Nothing on the machine has changed. Wet grass has less grip, so the tracks slide sideways under the weight. The fix is technique: stop until the grass dries, or work up and down where the manual allows, with slower travel and shorter passes. The machine rating of 45° applies to suitable conditions, not to wet grass on loose soil.

Settings that reduce drift

SettingChangeEffect
Travel speedSlower on the steepest partMore time for the tracks to grip
Cutting heightSlightly higher on heavy growthLess side load from the cutter
Pass lengthShorter passes across the bankLess distance to correct
Track tensionEqual on both sides, as the manual saysEven grip
DirectionAs the manual allows for your modelLess side force
Orange tracked remote mower cutting long grass on a riverbank slope
Tracked remote machine cutting long grass on a riverbank slope. Grip on banks like this changes quickly with wet grass.

When to stop work

  • The machine slides sideways rather than drifting slowly.
  • The tracks spin without moving the machine.
  • The ground is soft enough that the tracks cut into it.
  • You lose a clear view of the machine from a safe position.

Make the machine safe and wait. Recovering a machine from the bottom of a bank takes much longer than a short pause.

The video shows a MERI remote mower working on slopes in the 30–45° range.

MERI remote control slope mower working on 30–45° slopes.

Common mistakes on banks

  • Starting on the steepest bank first thing in the morning, when the grass is still wet with dew.
  • Turning on the bank instead of at the top or bottom.
  • Cutting very long grass in one pass, so the cutter load drags the machine downhill.
  • Standing below the machine to get a better view.
  • Assuming the 45° rating applies in every condition.

Regional note: in wet, mild climates, banks may be workable only in the afternoon for much of the year. Plan bank work for the driest part of the day and keep flatter areas for the mornings.

Related MERI pages

Frequently asked questions

Is downhill drift normal on a slope?

Some is; gravity pulls the machine down, especially on wet grass.

How do I reduce drift?

Slow down, follow the manual travel direction, avoid wet grass and keep track tension even.

What slope are MERI mowers rated for?

45° in suitable conditions.

What if it pulls on flat ground?

Check track tension, debris, idlers and the drive connections.

Send us your site details

Tell us the job, area, slope and country. MERI replies within 24 hours.

Ask MERI

Need a mower recommendation for your terrain or project?

Get a Quote
Get a Quote