Tracks Keep Coming Off on Side Slopes — remote control lawn mower article

Short answer: Tracks usually come off when tension is low, idlers or rollers are worn, debris packs between the track and wheels, or the machine turns sharply on a side slope. Set tension to the manual, clean the undercarriage, replace worn wheels and turn on flatter ground.

Why it happens on slopes

On a side slope the machine weight pushes sideways on the tracks. A sharp turn adds more side force. If tension is low or a guide is worn, the track can ride off the idler.

Checks

Do all checks with the engine off, the remote switched off and the machine secured, as the operator manual says.

CheckFix
Track tensionAdjust to the manual
Idler and rollersReplace if worn or seized
Debris in the undercarriageClean after each job
Track damageReplace if lugs or guides are torn

Check tension at the start of each day, and replace worn sprockets and idlers before they let the track run off.

Driving habits

  • Turn on flatter ground at the top or bottom of the bank.
  • Avoid counter-rotation turns on side slopes.
  • Slow down on rough ground.
  • Do not drive over kerbs and stumps at an angle.

Track sizes and parts

MERI stocks 150 × 30 × 37 and 180 × 30 × 37 tracks (MERI-P23, P24), the idler wheel (P28) and the large round wheel (P29). See the rubber track construction guide.

Refitting a track safely

Refitting a track that has come off needs the machine lifted and secured and the tension released as the manual describes. Do not try it on a slope. If the machine is stuck on a bank, make it safe and recover it to flat ground before working on it. Ask your dealer if you have not done it before.

Worked example: tracks coming off every week

A crew loses a track about once a week on the same long side slope. The track tension is close to the manual figure, but the idler on the downhill side has worn. The operator is also turning the machine on the steepest part of the bank to save time. After replacing the idler and moving all turns to the flat top of the bank, the problem stops.

Step-by-step: checking track tension

Follow the operator manual for your model. The general method is:

  • Park on level, firm ground, engine off, remote off, machine secured.
  • Clean mud and stones out of the undercarriage first. Packed mud makes a loose track look tight.
  • Measure sag at the middle of the top run, or as the manual describes.
  • Adjust both sides to the same figure.
  • Drive a short distance, stop, make safe and check again.
  • Check tension again after the first hours on new tracks, because they settle.
Tracked remote mower working on a grassy hillside
Tracked remote mower working on a grassy hillside. Turns on side slopes put the most sideways force on the tracks.

Warning signs before a track comes off

SignWhat it means
Clicking or jumping over the idlerLow tension or worn guides
Track sitting off-centre on the wheelsWorn wheel or bent frame
Shiny wear on track guide lugsTrack rubbing on the wheels
Mud packing on one sideDebris forcing the track outward

The video includes track adjustment on a MERI remote mower.

MERI remote control mower maintenance guide: air filter, engine oil and track adjustment.

Common mistakes

  • Running the tracks loose because it feels smoother on rough ground.
  • Over-tightening, which wears idlers and bearings and can stretch the track.
  • Driving onto a kerb or stump at an angle.
  • Making counter-rotation turns on a side slope.
  • Refitting a track on the bank instead of recovering the machine to flat ground.

Regional note: on sandy or stony sites, grit wears idlers and track guides faster. Check them more often there, and clean the undercarriage at the end of every day.

Parts to keep on the shelf

For a machine that works side slopes every week, keep one idler wheel and the track size for your model in stock: MERI lists 150 × 30 × 37 and 180 × 30 × 37 tracks, the idler wheel and the large round wheel by quote reference. A worn idler is a small part, but it is often the reason a track keeps coming off. Changing it early costs less than a lost day on the bank.

Related MERI pages

Frequently asked questions

Why do my tracks come off on slopes?

Low tension, worn idlers, packed debris or sharp turns on the side slope.

Where should I turn on a bank?

On flatter ground at the top or bottom.

What track sizes does MERI stock?

150 × 30 × 37 and 180 × 30 × 37.

Should I clean the undercarriage?

Yes, after each job.

Send us your site details

Tell us the job, area, slope and country. MERI replies within 24 hours.

Ask MERI

Need a mower recommendation for your terrain or project?

Get a Quote
Get a Quote