Orchard Spraying in Hot, Dry and Windy Conditions — remote control agricultural sprayer article

Short answer: In hot, dry and windy weather, fine droplets evaporate and drift before they reach the leaves. Spray in the cooler, calmer parts of the day, use the droplet size the label allows for drift control, and stop when wind or temperature goes past the label limits.

What goes wrong

  • Evaporation: fine droplets shrink in hot, dry air.
  • Drift: wind carries spray off target.
  • Inversions on still evenings can hold spray in the air.
  • Leaf stress: some products are less effective in heat.

Timing

ConditionAction
Hot afternoonWait for early morning or evening
Steady light windUsually workable within label limits
Gusty or strong windStop
Dead calm eveningWatch for inversion

Follow the product label.

Droplets and air

Use the coarsest droplet that still gives coverage. Reduce fan air on the windward side if the sprayer allows. Turn off outlets near sensitive areas.

Operator safety

Remote control keeps the operator out of the spray cloud, but heat stress still matters. Plan breaks, water and shade, and wear the protective equipment the label requires.

Records

Record temperature, humidity and wind at the start of each block. If coverage or results are poor, the records show whether weather was the cause.

Planning the week

When a hot, windy spell is forecast, bring spraying forward to the calmer days before it or wait until after, if the product timing allows. Spray the most sensitive blocks, such as those near houses or water, in the calmest window. Keep a weather log for each spray so decisions are easy to review.

Equipment checks in heat

  • Keep the tank mix agitated; some mixes separate in heat.
  • Check hoses and seals, which age faster in sun.
  • Watch engine temperature on long runs.
  • Store products out of direct sun.

Reading the conditions at the block

Forecasts help with planning, but decide on the day from what you measure at the block. Wind and temperature can differ between a sheltered valley block and an exposed ridge.

  • Measure wind speed and direction at canopy height.
  • Check temperature and humidity at the start, and again if the block takes long.
  • Note which way the wind blows relative to houses, water and other crops.
  • Watch for gusts, not only the average speed.
  • Stop and record if conditions go past the label limits.
MERI tracked sprayer tank, pump and hose assembly during a visual inspection
A MERI tracked sprayer tank, pump and hose assembly during a visual inspection. Product photo.

A hot-week spray plan

Time of dayTypical conditionsPlan
Early morningCooler, calmer, more humidMain spray window; sensitive blocks first
Midday to afternoonHot, dry, gustyMix, fill, service; do not spray
EveningCooling; wind may dropPossible window; watch for inversion
Dead calm nightRisk of inversionAvoid unless the label allows

Plan tank fills so the sprayer is full and ready at the start of each window. With tanks from 100 L to 800 L, match the tank size to the area you can cover in the window.

A remote control tracked sprayer in a peach orchard (MERI video library).

Worked example: fitting the work into the window

Say the calm morning window lasts three hours and the sprayer travels at 4.8 km/h in the rows. If the rows are 4 m apart, each kilometre of row covers 0.4 ha. Allowing for turns and a tank refill, plan for less than the full three hours of spraying, and spray the blocks nearest houses or water first.

Common mistakes

  • Starting late and spraying into the hot part of the day.
  • Judging wind from the yard instead of the block.
  • Finer droplets to “improve coverage” in hot, dry air.
  • No weather record, so a poor result cannot be explained.

After the spray

At the end of each block, note the finish time and conditions. Rinse the sprayer if the next product differs, and park it out of direct sun. If coverage papers or crop results look poor, compare them with the weather log first. Many poor results in hot weeks trace back to the time of day, not the product.

Related MERI pages

Frequently asked questions

Why avoid spraying in hot weather?

Fine droplets evaporate and drift before reaching the leaves.

When is the best time to spray?

Early morning or evening, within label wind limits.

What is an inversion?

A still layer of air that can hold spray aloft and carry it off target.

Does remote operation remove the need for PPE?

No; follow the label.

Send us your site details

Tell us the job, area, slope and country. MERI replies within 24 hours.

Ask MERI

Need a agricultural sprayer recommendation for your terrain or project?

Get a Quote
Get a Quote